Select Page



The KNX Gateway connects a PC to an EIB / KNX system via the EIB socket on our X1 servers in order to configure, parameterize and commission the EIB / KNX installation and the bus monitor using the ETS software.

This diagram represents a typical installation of our server that allows the installer to control and configure our server.

How the Home automation X1 server could be installed in a ipotetical KNX installation
Step 1:

Start EVE Manager Pro and connect from the Project -> Connect menu to your X1 server.

Connecting to the server with the ilevia's configuration software EVE Manager.
Step 2:

Once the connection has been established, go to the Tools -> Start KNX Gateway menu. This will initiate communication between the X1 server and the ETS software.

Activating the KNX gateway to enable the knx ip gateway mode to the Ilevia server.
Step 3:

Now let’s move on to the ETS software, by selecting the Bus screen you will notice that the communication was successful. Under “Current Interface” you will find your X1 server while on the right of the screen all the network details of your server.

How ot make an IP tunnelling from the Home automation components setup software ETS 5
Step 4:

When the connection is established it will be possible to use all the ETS features. In this example, correct operation can be verified by selecting Bus Monitor, which once you press Start, You will be able to see all the information crossing the KNX bus in real time.

How to check the feedback from the Home automation components from inside the ETS 5 software
Step 5:

Once the configuration is over on ETS, go back to EVE Manager and, from the Tools menu, click Stop KNX Gateway.

Deactivating the KNX gateway to enable the knx ip gateway mode to the Ilevia server.


In order to be able to connect to the server X1 with through KNX interface remotly, it will be necessary to access your Modem/Router configuration and open the port 3671 with the TCP/UDP protocol.

Now you will able to connect to your Server X1 through KNX interface in order to configure or make a dyagnostic check on the bus remotly.


In order to be able to configure KNX devices through the x1 server you will need to start the KNX gateway, then open your ETS software and load a project.

Once opened the ETS software select as knx interface the EVE server, that should pop up in the interfaces section in the bus section of ETS. Once selected you will be able to download the KNX devices configuration to its physical device through the Server EVE.

Still Need Help? Our Customer Service Is Here For You.